Questions about XYZprinting Da Vinci 1.0 Pro 3-in-1

Scanner is included, laser must be purchased but cannot be mounted on the normal one (-> 3-in-1 necessary..) ...

You can do anything if you want... With alternative firmware (Repetier) and a little inventiveness, it is certainly feasible... But of course the print space will be quite a bit smaller on one axis because two extruded parts have to sit next to each other.... Then 20cm can easily become only 10-15cm...

I would recommend asking the manufacturer directly. I also had frequent problems with the original software and then switched to Simplify3D. It's really worth it! Much better operation and printing results.

I have installed the Filaprint https://www.filafarm.de/products/druckplatte-fur-abs-und-pla?variant=5565870979 210x210mm and am satisfied so far (6 months)! Before that I had PET films, but they had to be replaced every few weeks.

yes, the part is ingenious. Simple operation and top results on wood and plastic. Cork rather unsuitable

yes, that's right, because the printer can't record all the data at once and the pc only passes on the data bit by bit, depending on the model, of course, the more complex the more data.

XYZprinting Da Vinci 1.0 Pro 3-in-1 only accepts ".stl" files. The 3D graphic can usually be converted/saved to the corresponding STL format when "Save as" (this is how it works with SolidWorks). The STL file can then be imported into the XYZprinting software.

the printer is offered on amazon by a "new seller" without a rating, and you have to contact them via e-mail before you order the goods. it doesn't even say where the printer comes from and how long it will take, since it is shipped. here the printer is available immediately! if it is too expensive for you, then order it from amazon, all other sellers on amazon have +/- the same price as digitec ;-)