CHF500.–
Wood's SW-38FM
140 m², 19 l/24h
Questions about Wood's SW-38FM
What would you like to know?
0 questions and answers
Helpful answer
Yes.
The Woods SMF filter fits all Woods units that have an F in the model number, so it will also fit the SW38FW. Explanation from Woods : "Wood's unique anti-mold filter, the SMF filter, comes with all Wood's dehumidifiers that have an F in the model number, as well as our new LD series of dehumidifiers."
digitec
5 months ago
Yes, you can connect the appliance to a timer so that it switches on between 3 and 6 a.m., for example, as soon as it has power. The dehumidifier then automatically measures the humidity and switches itself on or off depending on whether dehumidification is required or not. The appliance has a target humidity setting where it switches off when the set humidity is reached and switches on again when the humidity rises.
Automatically generated from the .
digitec
12 months ago
Helpful answer
To operate the Wood's SW-38FM dehumidifier with a condensation hose, you need the following:
- A commercially available hose with an internal diameter of approximately 12.5 mm.
- The hose can be connected directly to the drain connection of the drip tray of the dehumidifier by using a hose clamp.
No optional connection or additional accessories are required, apart from the hose itself. However, make sure that the hose is not higher than the outlet pipe and is not kinked to prevent flooding and damage to the appliance.
Automatically generated from the .
You can find our entire range of Wood's articles at the following link: https://www.galaxus.ch/de/brand/woods-16515
Helpful answer
Yes, that's why I bought the appliance. I am very satisfied. In particular, the control via the timer (in my case the house control) works perfectly. And the routing performance is of course also good.
I used a garden hose that I cut according to the distabce
Helpful answer
On earlier models you could adjust humidity exactly, but this has pre-set positions. The knob cannot be set between the pre-set positions, so the answer to your question is no.
Former employee
1 year ago
Unfortunately, we have no information on this at the moment.
Helpful answer
Yes, it has a float for switching off and the tank can be removed. However, I have raised the appliance on a stand and fed a hose into the sink.
Helpful answer
Hello, Wood's deliberately does not publish any specific figures. The reason for this:
high-quality, high-precision sensors from the Swiss manufacturer "Sensirion" (a spin-off from ETH Zurich) are installed in the Swedish Wood`s dehumidifiers. These sensors are significantly more precise than any commercially available hygrometer.
The following problem:
- Swedish dehumidifier is set to 50% and is on standby because the target humidity has been reached
- External commercial hygrometer shows 60%
- The person wonders why the dehumidifier is not running even though the room humidity is 60%.
- Person sends the appliance back to the supplier and complains about the defective hygrostat in the appliance
Solution to the problem:
- Hygrostat sensor in the appliance works perfectly - the effective humidity was below 50%
- The external hygrometer was a cheap device with a deviation of over 10%.
- The appliance was returned to the customer with the information: Everything is OK.
There have been many such cases in the past. For this reason, Wood's does not provide a specific declaration of the individual levels. As a guideline: At 12 o'clock there is approx. 50% residual moisture in the room. The more to the right, the drier the room - the more to the left, the more residual moisture in the room.
Kind regards
Manuel Rupp
Helpful answer
I can't tell you that. Our unit is in a laundry room. Question: Is the strength too high in a cold garage? Or do you mean a parking garage?
Can you send us a link to the product? :)
hier z.B. : Wood's SM Filter
19 of 19 questions