Best selling 3D printer accessories from Aprintapro

This page always stays fresh and updates automatically.

1. Aprintapro PrintaFix adhesive spray (250ml)

AprintaPro PrintaFix Adhesive Spray (250ml) - AprintaPro offers powerful solutions for makers. PrintaFix Basic is the solution for adhesion problems in 3D printing, eliminating warping. The application is simple: shake, spray, print. It is cost-effective for both heated and unheated print beds and can be washed off with warm water.

PrintaFix Basic is specifically designed for FDM/FFF 3D printing and is characterized by its ease of use, low cost per print (approximately 11 cents per print), and excellent adhesion on both heated and unheated print surfaces. PrintaFix surpasses previous methods of adhesion promotion through its simple application and higher adhesion.

Instructions: Shake, spray, print. Remove the print bed from the 3D printer, shake PrintaFix well, spray overlapping onto the print area, and start the print. This way, warping and first layer issues will be a thing of the past. The print bed can be cleaned with warm water or an alcohol-based window cleaner (must contain ethanol).

Additional information: Recommended print settings:
- PLA: Print temperature 200-215°C
- ABS: Print temperature 235-250°C
- Print bed temperature 80-100°C
- A 5mm brim provides a nice, smooth finish on the contact surface.

Multiple prints on one layer of PrintaFix are possible (adhesion decreases by about 20% per print, depending on the size of the previous prints). For extremely high adhesion: Spray PrintaFix as usual overlapping onto the print bed. Wait for the layer to dry, then spray a fine mist from a distance of +/- 30 cm onto the print bed. 

2. Aprintapro Printaclean 250

PrintaClean is a powerful solvent designed to effectively and easily remove even the most stubborn residues. Application: Spray PrintaClean onto the printing plate, let it sit for a short time, and then rinse off with a clean cloth or under warm water. 

3. Aprintapro Printstick

AprintaPro PrintaStick 50ml can be used with all printing materials and creates a strong bond to the print bed. The sponge applicator makes using PrintaStick simple, precise, and effortless. During application and printing, PrintaStick does not produce any unpleasant odors and leaves no visible residue on the 3D print after printing. The strong formula works for many materials.

Preparation: Shake the PrintaStick for a few seconds to mix the solution. Apply only on a cold, residue-free print bed. If necessary, you can remove residues from the print bed using PrintaClean. Apply PrintaStick by pressing the sponge applicator onto the print bed to release some liquid. Then, spread the liquid by moving the sponge in a circular motion over the print bed. When the sponge hardens, rinse it with clear water.

Finishing and Cleanup: Start the printing process with the recommended temperature settings. The liquid dries while heating the print bed, leaving a fine film that enables adhesion to the 3D print. Wash off with water after printing. 

4. Aprintapro Cleaning Needles 5 Stück

5. Aprintapro Printafix 100

AprintaPro PrintaFix Adhesion Spray (100ml) is the solution for adhesion problems in 3D printing, eliminating warping. The application is simple: shake, spray, print. It is suitable for both heated and unheated print beds and can be washed off with warm water. PrintaFix Basic has been specifically developed for FDM/FFF 3D printing and is characterized by its ease of use and excellent adhesion on both heated and unheated print surfaces. PrintaFix surpasses previous methods of adhesion promotion with its straightforward application and higher adhesion. 

Product order
See all products

Relevant lists