Aprintapro Printstick

AprintaPro PrintaStick 50ml can be used with all printing materials and creates a strong bond to the print bed. The sponge applicator makes using PrintaStick simple, precise, and effortless. During application and printing, PrintaStick does not produce any unpleasant odors and leaves no visible residue on the 3D print after printing. The strong formula works for many materials.

Preparation: Shake the PrintaStick for a few seconds to mix the solution. Apply only on a cold, residue-free print bed. If necessary, you can remove residues from the print bed using PrintaClean. Apply PrintaStick by pressing the sponge applicator onto the print bed to release some liquid. Then, spread the liquid by moving the sponge in a circular motion over the print bed. When the sponge hardens, rinse it with clear water.

Finishing and Cleanup: Start the printing process with the recommended temperature settings. The liquid dries while heating the print bed, leaving a fine film that enables adhesion to the 3D print. Wash off with water after printing.