CHF157.– currently CHF273.– new
Creality Ender 3 V2
Question about Creality Ender 3 V2
When I set up the printer and went to test it, the X-axis was not working correctly. The extruder started to shake and made a huge noise when moving on the X-axis. Apparently the belt is too loose, causing the gear motor to always skip "gears". The problem lessened as I tightened the belt more, but did not go away. Now it still buzzes and I can hardly tighten the belt any more.... Does anyone know the problem and possible solutions?
I would remove the X-axle again and then check very carefully whether the reassembly was done correctly. There are also good YouTube videos about this...