Silhouette Alta
Question about Silhouette Alta
When I print a small object directly in the centre, everything works fine. However, when it gets bigger (spread over the surface) the printer drags the filament behind it. What could be the reason for this?
At the top left it starts to pull this behind. I took out a failed print and will send it back tomorrow. I'm curious.
Same thing with me, but I ordered the Alta Plus from Brack, but then it seems to be a mistake on Silhouette's site.
A picture of the print would be handy. But it sounds like too much filament (overextrusion). Maybe this can be reduced or maybe the filament is not good (anymore).