Technaxx Balcony power plant
600 W
Question about Technaxx Balcony power plant
What about the RCD protection of the system? Does it comply with ESTI regulations? Furthermore, it is mandatory that either a residual current device (PRCD, type B, 30 mA)2) is installed in the mains cable or in the mains plug on the AC side of the product or that an AC/DC sensitive residual current monitoring unit (RCMU)3) is verifiably installed in the inverter/grid interface. The PV module, inverter, battery module (if applicable) and grid interface must form a single unit in order to be considered a freely pluggable product in the sense of the NEV together with the grid connection cable with plug (SEV1011) and PRCD. Greetings Stonee
Helpful answer
Without understanding the question in detail: the system was registered without any problems, including subsidies from EWZ. Since the system was not yet known there, I only had to send over all the documents and then it was positively checked.
The inverter is also not affected by the Deye problem.
Note: my system did not come with a German Schuko plug, but the Swiss type.
Hope this helps
These microinverters are extremely well protected and comply with the standards.
You don't need RCD protection because the system or microinverter shuts down immediately if it has no contact with the mains.
That is why they are also called Plug & Play.
The only thing that is important is the registration before commissioning!
I have submitted the attached documents to the local power supply and received written approval within 10 hours that all requirements have been met.
I hope this answers your question