If the sensor no longer measures the 5 points in the autolevelling correctly from one day to the next without misprinting or shifting in between on the far left plate and the plate is pressed down with the print head, is this then a warranty case or?

Question

Accepted Answer

I also had this problem. It is a production error and has to do with the fact that the sensor does not float completely above the print bed but is slightly to the left. I solved this by mounting something 3-4mm in between the limit switch on the left so that the sensor zeroes the X-axis further to the right. This way I had a much better flatness of the print bed even with the 25-point measurement. You can see this when comparing the 25 individual values.

Search

Question about Creality CR-10S Pro

If the sensor no longer measures the 5 points in the autolevelling correctly from one day to the next without misprinting or shifting in between on the far left plate and the plate is pressed down with the print head, is this then a warranty case or?