Anycubic Vyper
Question about Anycubic Vyper
Hello together Have any of you replaced the fans on the mainboard and the power supply? The original fans are very loud. The original fans on the mainboard are "Coolcox, CC8015H24S - 24V - 0.15A" and on the power supply "CCHV, CHA6024RL-15C - 24V - 0.10A". There are some models from SUNON which have been praised in various forums. On Distrelect or Reichelt you can find some of them in 24V. I don't want to convert to 12V because the issue with StepDown etc. is too complicated. Please give me constructive feedback. Many thanks :)
Helpful answer
Sali
I would also be interested. I changed the hotend fans because I was annoyed by the whining that occurs when the power is below 100%. However, this is still present after the change.
I ordered the 2 Sunon because they are really cheap... The fans remain quite loud... I find the noise itself slightly more pleasant, but the volume remains about the same. So if you bother to change them, then install Noctua with a 12V stepdown...
The Sunon replacement is easy, doesn't cost much and has been subjectively worth it for me, but the noise level remains. For me, it comes in a housing, so I don't bother with the conversion any more, if I were to operate the printer openly in the room, I would do the stepdown variant.
I hope this statement helps you. LG