Creality Ender 3 V2
CHF157.– currently CHF273.– new

Creality Ender 3 V2

Question about Creality Ender 3 V2

avatar
Dany1970

3 years ago

As a 3D printer newbie: I only have Mac, so I assume that's not a problem. There is enough SW and at the end you put the file on an SD card into the printer and off you go? Thanks for your patience :-)

Avatar
avatar
gschwinds

3 years ago

Helpful answer

The print object must be prepared with a so-called slicer programme before it lands on the SD card. Of course, these are also available for MacOS and most of them are free of charge. For example, the one from Creality itself https://www.creality.com/de...
Then there are Cura, PrusaSlicer, Simplify3D, etc.

You can try out the programmes before you buy a 3D printer and familiarise yourself with them. I would advise you to look at instructions and tutorials on the Internet and on YouTube.