CHF239.–
Kibernetik M50
120 m², 50 l/24h
Questions about Kibernetik M50
What would you like to know?
0 questions and answers
First, switch off the Kibernetik M50 and unplug it from the mains. The dust filter is located at the air inlet and can be vacuumed or wiped clean easily. If it is very dirty, you can use warm water with a small amount of medium-strength detergent.
The activated carbon filter is not washable and should be checked approximately every six months and replaced if necessary. Unfortunately, we do not currently have a suitable replacement filter for the M50 available in our range. We therefore recommend that you contact the manufacturer’s support team directly: https://support.kibernetik.ch/hc....
As soon as the set humidity is exceeded again, the compressor switches on automatically. The fan continues to run depending on the operating status.
Helpful answer
I always set the humidity to 35%. With the standard setting, the appliance has no interest in drying the air :-)
Greetings!
Was the item ordered at the same time? If not, there may well be price fluctuations because the purchase price has changed. However, this does not affect the product and you should have noticed this on the order confirmation.
In this case, you should contact customer service
Helpful answer
Yes, the drain hose was included in mine.
So the specifications are correct. I also have this dehumidifier and it is really good. It's just that the dehumidification doesn't work from an outside temperature of about 5 degrees and below.
Former employee
5 years ago
Unfortunately, delivery times can never be certified. The approximate delay is mentioned on our website :)
Former employee
5 years ago
This happens from time to time, e.g. with articles that will no longer be delivered this year or produced in such small quantities that the next available delivery date is only in a few months.
If the item is available earlier, the delivery date will be adjusted in the shop.
Helpful answer
Hello lukasbührer
I have only recently put the unit into operation. According to the operating instructions, the "Timer" button is described under point 3. This can be pre-programmed up to 24 hours (from 1,2,3 - 24). In my opinion, an "external" timer can only interrupt the power supply and therefore switch off the appliance after a certain time. The timer will supply power again after a programmed interruption of the electricity, but it will not put the appliance back into operation. To do this, the "Power On/Off" key must be pressed again. Reason: when the power cable is plugged into the mains for the first time, the unit does not switch on automatically.
Greetings
Former user
8 years ago
Helpful answer
Unfortunately not. You have to switch on the dehumidifier using the on button or the remote control. You can only do this by disconnecting the power and reconnecting it (external timer). You have to empty the water tank manually anyway, unless you have a direct water drain.
Helpful answer
Response from the retailer:
It may be that fluff or dust has become trapped inside. You can remove the water tank and loosen the screws on the side and at the bottom of the appliance.
You can then take the two parts apart and clean the inside of the appliance with a cloth.
You are also welcome to send the appliance to us and we can carry out the cleaning for you, although this is not covered by the warranty.
Helpful answer
No, you are not doing anything wrong. The unit is actually always running. When the target humidity is reached, the compressor is deactivated. You can see this very well when you measure the power consumption. The ventilation, on the other hand, remains in operation.
Former employee
9 years ago
Unfortunately, there is no energy label for this appliance. Energy labels are not yet mandatory for dehumidifiers.
14 of 14 questions