MicroSwiss Micro Swiss Plated Wear Resistant HeatBreak - V6 1.75mm Direct and Bowden HotEnds

This heat break is a direct replacement for use in E3D v6 1.75mm hot ends.

This tube is made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction electroless nickel composite coating, often used in injection molding because of its release properties. This high lubricity plating will prevent clogging in the critical zone of the hot end, where filament liquidizes. It is also very hard and corrosion resistant, making it great for high abrasion filaments like carbon fiber, metal-filled, and aluminates.

Fits:

• E3D v6 1.75mm direct and Bowden hot ends

Dimensions:

• Thread size on heater block side: M6x1
• Thread size on heatsink side: M7x1
• Stepped inside bore to improve PLA printing.

Made in the USA by Micro Swiss.