Bondtech IFS Extruder for Prusa Mini or Mini+

Bondtech IFS Extruder for Prusa Mini or Mini+

Upgrade your Prusa Mini or Mini+ with the Bondtech IFS Extruder.

Filament Sensor Compatible
The Bondtech Internal Filament Sensor Extruder for Prusa Mini can embed the new Prusa filament sensor for Mini or Mini+ in its housing. The extruder can be used with or without the filament sensor.

Upgrade Your Prusa Mini or Mini+
Enhance your Prusa Mini or Mini+ with a Bondtech Dual Drive extruder designed to seamlessly fit the original setup.

Hardened Drive Gears
Allows the use of abrasive materials that would otherwise wear out the gears of your original feeder.

Adjustable Tension
The thumbscrew tensioner allows the user to fine-tune the pressure exerted by the drive gears onto the filament. This gives you the power to adjust according to your preferences and optimize for the type of material you are using.

Quick-Release
To facilitate material changes quickly, simply activate the Quick-Release lever to release the tension and pull the material to be changed out of the extruder. Keep it activated and insert the new material.

More Choice of Materials
The hardened steel Dual Drive gears allow you to work with common and abrasive materials.

Included in this Kit

• 1x Bondtech IFS extruder for Prusa Mini
• Prusa Filament Sensor
• 1x 10076-4 IFS Magnet Holder (PA12)
• 1x 10076-5 IFS Lever (PA12)
• 1x 15112 IFS Extruder Plug (HT-PLA)
• 3x Black nylon zip-ties
• 4x M3x35 black oxide steel screws
• 1x M3x12 black oxide steel screw
• 1x Brass motor gear
• 1x Thumb Screw assembly

Community Sourced Design
The original Bondtech extruder for Prusa Mini design was proposed by Olof Ogland. This new IFS version was developed by Vecko Kojchevski based on Olof’s work. It’s based on the thoroughly tested BMG (Bondtech Mini Geared) and adjusted to the Prusa Mini original design.

Not Included in this Kit
Filament Sensor Magnets
Filament Sensor Steel Sphere.