How do you connect the 50A flip sensors to a 3 EM? There are bare cable ends on the flip sensor, while on the Shelly 3 EM there are only plug-in connections. I have also not found a way to change from 120 to 50A in the settings.

Question

Answer

Solder on the corresponding plugs. Otherwise, the supplied "flip sensors" are calibrated with the EM3 to the respective phase and are therefore labelled separately. If the phase is mixed up or a 50A version is used, at least the calibration (with a measuring load) must be started. However, I cannot say whether the EM3 also tolerates other "flip sensors".

Search

Question about Shelly 3EM

How do you connect the 50A flip sensors to a 3 EM? There are bare cable ends on the flip sensor, while on the Shelly 3 EM there are only plug-in connections. I have also not found a way to change from 120 to 50A in the settings.