CHF130.–
Casaria Desk with adjustable height
110 x 60 x 118 cm
Question about Casaria Desk with adjustable height
Hello, I need to clarify something. The manual says: "The control unit can be mounted either on the left or right under the tray, make sure that the motor is always mounted on the same side as the control unit. ...". The original direction of the manual shows the control unit on the right. I want the control unit on the left. Does "same side as the control unit" mean putting the motor on the left or the motor in front as for the right? a) If it's in front, the motor stays on the right. Is the cable long enough? It looks rather short b) If it is also on the left, the motor must be fitted from the rear, as there is no 2nd hole in front. This will reverse the rotation of the tiller and the motor will be upside down. Is this OK? because it can reverse the rise and fall. So, do the motor and control unit adapt to each other or will the buttons be reversed? Thanks in advance.
The control unit and the motor are each mounted on the same side, in your case on the left. The control unit at the front, the motor at the rear. The only thing that changes are the drive rods. The short one is then on the left and the long one (two connected parts) is on the right. Nothing needs to be turned round. If you mount the whole thing on the floor (table top upside down), you will of course have to rethink things accordingly. Good luck
Hello
The control unit and motor must be on the same side (short cable). The installation can be mounted on the right or left. I do not see that the motor direction can be rotated.
The positions (standing and sitting) can be memorised.
Hope I could help...
The control unit and motor must be on the same side (short cable). The installation can be mounted on the right or left. I do not see that the motor direction can be rotated.
The positions (standing and sitting) can be memorised.
Hope I could help...