Questions about Sonnenkönig Window kit

I had the same problem, I used a dry glass-ceramic scraper but I had plastic window frames and I had to be careful. And a lot of patience and elbow grease. You can also try force 5, it dissolves but the glue goes a bit mashed Courage

The window kit is only used to seal the window, to lead the pipe out of the window. I don't know which air conditioner you mean, but you can use any pipe.

It depends if you have it installed like I do. I have zip ties going through the zippers to keep them tight around the ac exhaust. Of course you could always cut them off if you want to open the window. In practice, yes you can unzip it and then open the window. It might just be a bit awkward but definitely possible.

In such a case, you would need to contact our customer service directly. Here are our contact details: https://www.digitec.ch/de/information/contactinformation .

Well the material’s job is to create a thin barrier between the inside and the outside while the window is open. If mounted properly it works perfectly fine, but I had to also ensure other small cracks at the joints of the window are covered all the way. In short, yep it works, but have few small cloths around for those little holes. hope this helps.

You only need 1 window kit, unless it is a huge window (circumference over 400 cm), but I don't think a skylight is bigger. The window kit consists of two parts that are connected with a zipper, one for the window and one for the frame. The parts are connected with a zipper.

the scope ist around 400cm so you can adjust it to your window and air conditioner