CHF9.25 per piece for 2 units
Phobya Y-cable 4Pin PWM
Questions about Phobya Y-cable 4Pin PWM
What would you like to know?
0 questions and answers
Helpful answer
Yes, you can. But then the control of the fans by the mainboard (PWM) will not work. Only control by voltage will then work.
At first glance, I would say no. The cable is designed for fans. I'm afraid that with a usb signal it will cause impedance and power supply problems. I'm afraid that with a usb signal it will cause problems with impedance and power supply, so it's better to use a usb switch or an expansion card.
Because only one fan regulates the speed - the others run in parallel
Hello, that is also correct. The 4pin is the master, which sets the speed and the 3pins follow this speed as slaves. There cannot be two or more 4Pins because there is only one speed :)
yes, but be sure to read the return policy.
Helpful answer
It depends. Decisive are both what your motherboard can deliver at maximum power on the connection, and how much power the fans draw when starting up, and how much during operation. The latter in turn depends significantly on whether they are operated at 100% PWM signal or less. The voltage is always 12V, but the current and thus the power consumption are typically highest at 100%. I run five Noctua 140 mm fans on an ASUS gaming board at around 800-1200 rpm without any problems.
Helpful answer
As far as I know, the Rampage V Extreme offers 8 connections for fans. Attached is a picture: https://www.asus.com/websites/global/products/SNYTZvOdMa6xGWYL/img/staycool/staycool-fan-1.jpg PS: No fighting here!
This should not be a problem if they are equipped with LEDs. However, we recommend that you use a fan controller.
12 of 12 questions