CHF76.90
Neomounts Monitorius flat screen table mount
Table, 32", 6 kg
Questions about Neomounts Monitorius flat screen table mount
What would you like to know?
0 questions and answers
It is most likely not possible to reorder. But you can certainly find similar screws in a DIY store or on the Internet. They don't necessarily have to be the same. They simply have to be about the same length and have the same thread.
Helpful answer
Yes it works without a problem! I attached a 34" to the bottom and a 32" to the top.
Former employee
2 years ago
Thank you for the detailed review. So that your review gets more attention, you can also place such feedback in the review section in the future.
Former employee
3 years ago
Helpful answer
The items have different EANs, so they are not the same item.
Xanton 7640165932261
Newstar Neomounts 8717371447090
As to whether the manufacturers have the same sub-manufacturer or supplier, we can't know :) The item is a monitor mount, a simple one, so there is not much difference in appearance and design.
Helpful answer
The mounts are on clamps that you can slide up and down, they can be removed if you don’t want them.
Helpful answer
No, it cannot be tilted. It is directly connected to the pole.
Good day,
definitely! To be exact, currently even 252 alternatives. You just have to know how to use the filters.
You can find all the alternatives under the following link. If you want one from NewStar, you can also select the manufacturer in the filter.
https://www.digitec.ch/de/s1/producttype/monitorhalterung-1986?opt=v1368-11853%3A1&pdo=1368-8289%3A178142&tagIds=77-624
Kind regards
Niklas
as long as both support areas are flat the 2cm shouldn't matter.
Helpful answer
The bar cannot be rotated because it is fixed on the clamp, but the screen support is "free" so it can rotate around the bar without any problem.However, I do not recommend this manoeuvre because the weight of the screen would then be opposite the clamp and therefore it will create at best an imbalance and at worst a breakage.
You can rotate the brackets freely, they are just clamped to the rod.
The brackets themselves also have joints that can turn about ± 90° (not quite).
Be wary of the maximum weight of one screen, I tried attaching a screen that was way too heavy, but for normal screens like specified it should work just fine.
Former employee
4 years ago
Unfortunately not.
Helpful answer
I have a 34" on the bottom and a 27" on the top.
So your setup will work too
Should be 3.5cm... 😆 I can't reach it that well anymore...
I have a 43" monitor at the bottom (approx. 15 kg) and it is so barely stable, and a 24" monitor at the top. However, I had to put the 24" monitor at the top almost at the end of the bar. I can't imagine that with 49" and 27", but I'd be happy to be convinced otherwise ;)
The highest suspension point is 85cm above the tabletop.
If the height of the Imac and half of the height of the second monitor together is less than 85cm then it might fit.
Yes, I have mounted a 32" Curved myself. As long as the screen has a monitor mount, everything should be no problem.
The problem has become a smaller one. Most of the weight specifications for monitors include the stand. You can subtract 1-4kg depending on the model.
Helpful answer
I think that would not be a problem. You have the option of drilling a hole in the table or screwing the monitor holder to the table. In both ways it is no problem to change the table.
Former user
6 years ago
26 of 26 questions