Purecrea W1209 24V temperature controller with relay switching

The W1209 module features a temperature sensor and a relay circuit. This allows for easy construction of a temperature control system, such as for a 3D printing chamber. The target temperature at which the relay activates can be set using the three buttons: set, +, and -. This can be used, for example, to turn on a fan or heating device.

Warning: The board indicates 12V, but the relay only activates when powered with 24V.

Instructions:
Connect the temperature sensor, the 24V operating voltage (terminal +12V and GND), and your desired load (terminal K0 and K1) to the PCB.

After briefly pressing the SET button, the display will blink. You can now set the target temperature using the + and – buttons.

If the SET button is pressed for longer than 3 seconds, the P-menu will be accessed. Here, various parameters can be set, with option P0 being the primary focus, where you can choose between mode H and C. In mode C, the relay activates when the target temperature is exceeded. In mode H, it activates when the target temperature is not reached.

Confirm the selected target temperature and P-settings by pressing the SET button again.

The module now displays the measured temperature in real-time and activates the relay based on the P0 value when the target temperature is reached.

Possible error codes: LLL = The temperature sensor is not properly connected. HHH = The measured temperature is outside the measurement range (-50-110°C).

Technical details:
Voltage: 24V
Relay: max 5A at 24V
Temperature range: -50-110°C
Tolerance: 0.1°C
Update rate: 0.5s
Mounting holes: Ø3.6mm
Length of temperature sensor: 30cm
Dimensions: 40 x 48 x 16mm
Weight: 20g

Included in delivery:
1x W1209 24V temperature controller with relay circuit
1x Temperature sensor 30cm.