Metz Connect BTR 11084413 MR-LD6

Metz Connect Modbus Module 11084413

Manufacturer: Metz Connect
Designation: Modbus Module MR-LD6
Modbus RTU Type: 11084413
KNX Bus System: no
KNX Radio Bus System: no
Radio Bus System: no
LON Bus System: no
Powernet Bus System: no
Other Bus Systems: others
Remote Control Possible: yes
Ethernet: no
Mounting Type: REG
Width in Division Units: 3
With Bus Coupling: yes
LED Control: yes
With LED Display: yes
Local/Manual Operation: yes
Number of Inputs: 6
Suitable for C-Load: no
Switching Function: yes
Rated Operating Voltage: 24 V
Various Phases Connectable: no
Protection Class (IP): IP20

The Modbus module with 6 analog inputs and 2 relay outputs has been designed for decentralized switching tasks. It is suitable for monitoring electrodes from leakage sensors or the level of liquid containers, as well as for switching pumps or solenoid valves. The relay contacts must be protected by appropriate load-dependent measures. The resistance of the conductive liquid is measured when the electrodes are submerged. Additionally, it is possible to report a cable break (LKS-ZD sensor required). The device can operate autonomously or via a Modbus master. The inputs and outputs can be switched and queried via standard registers. The module address, bitrate, and parity can be set using two rotary switches on the front or via software. It is suitable for decentralized mounting on TH35 mounting rails according to IEC 60715 in electrical distribution boards. Connection via screw terminals.