Eltako FZS65-wg Radio pull-cord switch surface-mounted Range max. (in free field) 30m

Radio pull switch for surface mounting 84x84x24 mm or for installation in the E-Design65 switch system. With silver and red handle. It generates the energy for radio telegrams, hence no connection cable and no standby loss. Smart Home sensor. When pulling and releasing the handle, a radio telegram is sent in the Eltako building radio system. The delivery includes the fully assembled pull switch, a silver handle, a red handle, and two screws with dowels.

Installation by screwing: First, disassemble the fully assembled pull switch. To do this, remove the screw, unhook the cover, and take out the intermediate frame including the rocker and transmission module by loosening the retaining brackets at the top and bottom. Attach the mounting plate by screwing it in. Snap the frame with the upper hanging cutouts onto the intermediate frame including the transmission module and rocker, with the rear marking 0 facing up. Hang the cover with the cord through the upper hanging cutouts of the frame and secure it at the bottom with the screw in the mounting plate. Cut the cord to the desired length, thread it through the red or silver handle, and secure it with a double knot.

Position-independent: The pull switch works in any position, even when mounted on the ceiling. Compatible actuators: The radio pull switch sends the same radio telegrams when activated as a radio push button and can therefore be learned into actuators and the GFVS software just like it. If it is learned as an emergency call switch into an actuator as central, an emergency call can only be acknowledged via another learned push button with central acknowledgment. The radio module contained in the radio pull switch can be encrypted into all encryptable actuators of series 61, 62, and 71 as well as into the FAM14. For this purpose, the radio push button encryption rocker FTVW is required. Encryptable actuators bear the key pictogram.