The TL-WPA4220 kit is a separate access point and cannot be set up directly as a Wi-Fi repeater to be transparent. However, it offers a function called "Wi-Fi Clone", which copies the SSID and password of the main network to enable a seamless connection. While this function helps with setup, it will always show a separate network as most devices do not automatically switch between networks.
To use it as an access point, it must be connected to the router via an Ethernet cable, which allows the signal to be amplified in a different area.
๐ง๐น;๐ฑ๐ฟ: ๐ฑ๐ฎ๐ ๐ฆ๐ฒ๐ ๐ถ๐๐ ๐ฎ๐น๐ ๐๐ป๐ฑ ๐ฏ๐๐ด๐ด๐ ๐๐ป๐ฑ๐ฑ ๐ฏ๐ถ๐ฒ๐๐ฒ๐ ๐ฑ๐ถ๐ฒ ๐ฒ๐ป๐๐๐ฝ๐ฟ๐ฒ๐ฐ๐ต๐ฒ๐ป๐ฑ๐ฒ ๐๐๐ป๐ธ๐๐ถ๐ผ๐ป๐ฎ๐ถ๐๐ฎฬ๐ ๐ป๐ถ๐ฐ๐ต๐ ๐บ๐ฒ๐ต๐ฟ. ๐จ๐ป๐ฑ๐ฑ ๐๐ฎ๐น๐ฎ๐ ๐๐' ๐ฒ๐ป๐๐ณ๐ฒ๐ฟ๐ป๐ฒ๐ป ๐ฎ๐น๐น๐ฒ๐ฟ ๐๐ผ๐ฟ๐บ๐ฎ๐๐๐ถ๐ฒ๐ฟ๐๐ป๐ด ๐ถ๐๐ ๐๐ฐ๐ต๐ฒ๐ถ๐๐๐ฒ. Wifi-clone is a quick setup function similar to WPS (+ button on Swisscom internet box) in bad, with a bunch of problems. It had another corresponding function, which is why I bought it, but that has long since been patched out, the device is also a good 10 years old. It's also the cheapest in the range, so I'm not complaining that it only manages just under 20 MB/ at best and needs a reboot every week, and both are always close to overheating.
