CHF66.55
Lian-Li UNI FAN SL-INF Reverse Blade
120Â mm, 1Â x
Question about Lian-Li UNI FAN SL-INF Reverse Blade
Hello together I have a small question regarding fans for my case I have the Lian Li O11 Dynamics XL I can fit three 3x120 fans and 1x120 fans in my case. I would like to install these fans https://www.digitec.ch/de/s1/product/lian-li-uni-fan-sl-inf-120-120-mm-3-x-pc-luefter-21233127 Lian Li Uni Fan SL-Inf. Now the question so that everything looks good. Do I need 2 3x120 of these and then 4 SL-Inf 120 reverse blades to blow the air outwards? Otherwise the fans would not look the same. Then another question, would you blow air into the case at the bottom and sides and out the top and back? Thanks in advance
A few weeks ago, I created the following configuration with an O11D Evo RGB:
Bottom 3x 120mm UNI FAN SL-INF Reverse
On the side 3x 120mm UNI FAN SL-INF Reverse
Top 3x 120mm UNI FAN SL-INF on a Galahad II Trinity Performance 360 instead of the pre-installed ones.
Rear 1x 120mm UNI FAN SL-INF
Next time, I would use 3x 140mm at the top and 3x 140mm at the side, as the 120mm also look relatively too small in the O11D Evo RGB. And I would also avoid the fuss with the FAN controllers 🙈
You can do it like this or change the pins. There are instructions with the regular ones on how to do this
Mfg
Hi. With the o11d xl, as with the rgb, you can work with 3x 140s both at the bottom and on edge because the case is almost too big for 3x120s. They almost look too small.
Just have a look on YouTube for o11 evo xl and take a look at the shorts. You'll see what I mean.
Yes, the bottom and sides are virtually 6 and the top with aio and two at the back are 5. So so-called positive pressure. Better to install more intake than outtake.
You need 3x120mm reverse at the bottom and sides, 3x120mm normal at the top and 1x120mm normal at the rear. Or you can use a Lianli galahad SL Inf Aio at the top, there are already 3 of them. Lian-Li Galahad II 360 Trinity SL-INF