Hello everyone, I bought this board and have already installed it in my system. Everything is great except for the fact that I use DDR5 RAM (Corsair Vengeance RGB, DDR5, 32GB (2 x 16GB), 5600MHz - white) but they only run at 4800 clock. If I set the bios to 5600 the PC crashes and has to be rebooted and the BIOS reset in boot mode. According to the instructions, the board should support 5600. Can anyone help me?
Nino
2 years ago
Helpful answer
Using the same board, did you manually set the ram to 5600MTS in the BIOS? If so, you can activate the XMP profile instead. This will ensure that the correct timings are applied.

Question

Hello everyone, I bought this board and have already installed it in my system. Everything is great except for the fact that I use DDR5 RAM (Corsair Vengeance RGB, DDR5, 32GB (2 x 16GB), 5600MHz - white) but they only run at 4800 clock. If I set the bios to 5600 the PC crashes and has to be rebooted and the BIOS reset in boot mode. According to the instructions, the board should support 5600. Can anyone help me?

2 years ago

Helpful answer

Using the same board, did you manually set the ram to 5600MTS in the BIOS? If so, you can activate the XMP profile instead. This will ensure that the correct timings are applied.

Accepted Answer

Using the same board, did you manually set the ram to 5600MTS in the BIOS? If so, you can activate the XMP profile instead. This will ensure that the correct timings are applied.

Search

Question about Gigabyte Z790 AERO G