Question about Playseat air force

I have now had my colleague make adapter boards from the 3D printer. Now everything is where I wanted it. I only screwed the yoke directly onto the board and plastic (drilled new holes). For the throttle I cut a plastic plate that serves as a mousepad.
However, I think the product is marketed incorrectly! It should be more precise in the description which products fit on the seat and which do not.

Good evening. I too have made this observation. I would have liked the side plates to be even higher. My solution was a small table on the right and a thick wooden plate on the left, screwed onto the plate from below, for my X52 Pro with the suction cups supplied. Alternatively, I would have tried to find a solution from below with nuts and screws or through the hole in the corner on the X52 with a long screw. Good luck.