CHF60.90
Thermal Grizzly WireView GPU, 1x 12VHPWR - Reverse
Question about Thermal Grizzly WireView GPU, 1x 12VHPWR - Reverse
Does anyone know how much space the Wireview needs between the HPWR connector of the graphics card and the side panel of the case? Unfortunately, I can't find any information on this anywhere.
Helpful answer
There is no general answer to this, it depends on how deep the 12VHPWR socket is mounted in the graphics card.
But from the socket it is exactly 26mm.
Attention, if you have an EKWB water block with active backplate, WireView does not fit! The backplate is too thick, the distance between plug and socket on the WireView is too small.
Hello, mine is 24mm
Hello Raphael, I have at least 23mm built in.
Exactly, I measured 26.5mm from the edge of the bushing. Regarding the backplate: The two plugs are offset by 11mm (centre distance approx. 20mm).