Questions about Netatmo Smart Radiator Thermostats + Hub

So I also have an underfloor heating and am just thinking where you would mount this 🤔 So I think less that it works :)

The Netatmo Starter Pack, which includes the Hub, is a basic package that forms the basis for the Netatmo smart home system. The thermostat itself is a separate device that can be added as an option to control the radiator thermostats. You only need the thermostat if you specifically want to make the radiator thermostats in your home smart and control them via the Netatmo system. The Starter Pack allows you to set up the network and integrate other Netatmo devices, but it does not automatically include the thermostat for the radiators. This must be purchased and installed separately.

The connections and transition pieces fit old and newer Danfoss. I'm not sure about Ran, but I think it should work.

This set contains 5 thermostatic valves.

I don't think it works. The head has to be in the same room, as it has to be able to measure the temperature. With underfloor heating, all the valves are usually centralised in a technical room.

France (see Wikipedia)

It has adapters for all common temperature controllers. A compatibility list is also available online at Netatmo.

Yes, that is possible. There is even a frost monitor in the app so that the temperature never falls below a certain level. Using the thermostats, you can also always see the temperature on the individual radiators. If the battery is not empty.

Hello Mu31 You simply need a smartphone/tablet and download the Netatmo app "Energy". Apple: https://apps.apple.com/ch/app/netatmo-energy/id730893725 Android: https://play.google.com/store/apps/details?id=com.netatmo.thermostat&gl=CH Then "Install new product" in the app. You will then automatically be asked about WLAN. It is not possible with an Ethernet cable, correct. There are various good videos/sites that also helped me to get an overview: Overview page https://www.netatmo.com/de-ch/energy/valves/installation There you will find video instructions, e.g. right next to the picture sections "Thermostatic valves" or "Manual valves". Further down, in the section "How it works", there is another similar video, or a PDF manual. As stupid as it sounds, it's actually quite simple - but somehow not. But the videos helped me. Important: Don't despair. Be patient. Especially when the thermostat valves show the exclamation mark. (as soon as you insert/remove the batteries - or restart the relays) Always give the system enough time, approximately 5-15min. Also, if it happens that the thermostat motor is at the very back and has no contact with the heater pin, give the thermostat time. Or you can always restart the relay (the settings / WLAN are retained). Furthermore, after 2 months the original batteries were empty. Instead of replacing the batteries again, I took them out and put them back in. Since 3W it has been quiet in any case. Unfortunately I don't have a battery tester at hand - but I hope they are not effectively empty. Apparently they should last up to two years. PS. You can change the temperature for "Frost monitor" and "Absent" in the app under: Settings > My plan > at the very bottom on "Change temperatures" > at the very top (!) set frost guard / absent. Hope I could help a little Kind regards Actino

Here are the contents of the delivery according to the product number: 5 intelligent radiator thermostats, 1 connection module, 5 x 6 radiator adapters (M30x1.5, M30x1.0, M28x1.5, Danfoss RAVL, Danfoss RA, Giacomini), 2 x 4 coloured stickers, 2 x 2 AA batteries, 1 socket. This product contains four colour options (stickers) "Give your radiator thermostat a personal touch with one of the four coloured stickers supplied.

You can also benefit from the money-back guarantee with us. Netatmo will be adding to us in the next few days.