Eltako LED Dimmer DALI 16 A R

DALI LED dimmer with RGB color control for ceiling installation. Standby loss is only 0.12 watts. Suitable for controlling constant voltage LED modules (CV) with operating voltages from 12V to 48V. Operating mode DT8: one DALI address for controlling brightness and color (DALI DT8, type RGBWAF). Operating mode Colour&Dim: control via 2 DALI addresses, one for adjusting brightness and one for adjusting color. SwitchDim2: operation via 2 switch inputs allows control of brightness and color without DALI. Dimming range 0.1%-100%. Switchable PWM frequency (122Hz/244Hz/488Hz/976Hz). Supply voltage 12V to 48V DC (corresponding to the operating voltage of the LED modules). Connection current 16A. The maximum connection current can be distributed across the channels as needed. Low standby losses. High efficiency. Configuration via PC software DALI-Cockpit and DALI-USB interface. Operating modes: The device has several operating modes: DT8 (default setting): In this mode, brightness and color are controlled via one DALI address (Device Type 8). Alternatively, operation can also be done via two button inputs (SwitchDim2): SwD1: Brightness. Short press: On/Off. Long press: Dimming. SwD2: Color. Colour&Dim: This mode is used for controlling RGB lights. Control is done via 2 DALI addresses, with one address influencing brightness and the other affecting channel distribution (e.g., color). The Colour & Dim mode allows color adjustment without affecting brightness and vice versa. Adjustments are made with DALI standard commands such as Dim Up/Down and can therefore be used with all common controls and gateways (e.g., KNX). This control option provides an alternative to the DT8-RGBWAF mode. Operable via DALI or SwitchDim2: DALI address 1, SwD1: Brightness. DALI address 2, SwD2: Color.