Creality Laser Falcon Engraver-5W
Question about Creality Laser Falcon Engraver-5W
I have the 5v Falcon, during the first tests I noticed that the laser never cuts at a right angle when cutting 1 mm cardboard, what can I do?
If you haven't already done so, make sure when tightening the focussing screws (the 2 screws that hold the laser) that the laser is flush with the X-axis. Mine has a good 1-2mm play.
Hope this was helpful :)
LG
Hope this was helpful :)
LG
Have you secured the box so that it doesn't move?
In my case, it once shifted slightly just from the draught from the fan.
In my case, it once shifted slightly just from the draught from the fan.