CHF400.–
Electrolux Chill Flex Pro
50 m², 12000 BTU/h
Question about Electrolux Chill Flex Pro
Hello, I bought the system new and when I ran it in cool mode at the lowest cooling capacity of 16 degrees, it cooled permanently in hot weather. Recently, when it is a little less warm, the system only turns on the compressor sporadically, the cooling capacity is so low. Does it check the room temperature and only provide full cooling when really necessary? In this case, the room temperature is approx. 25 degrees. Is this set for economic reasons? It is not in car mode, so it should make cold air permanently. Does anyone know anything about this? Greetings Beat
The unit switches to low mode when the temperature is reached. If the temperature rises above the set temperature, it cools more strongly again.
(Thermostat) However, the temperature is measured on the unit itself and does not necessarily reflect the room temperature. If I enter 24° on Auto, the system already reduces at 24.7°. If that is not cool enough, simply set it one degree lower and it cools more.
In my experience, cooling down is faster with the Swing setting. The air mixes better.
(Thermostat) However, the temperature is measured on the unit itself and does not necessarily reflect the room temperature. If I enter 24° on Auto, the system already reduces at 24.7°. If that is not cool enough, simply set it one degree lower and it cools more.
In my experience, cooling down is faster with the Swing setting. The air mixes better.