Creality Falcon

Creality Falcon

Question about Creality Falcon

avatar
DAWE89

6 months ago

Hello everyone I have ordered the 10 Falcon and built it today. Unfortunately, it won't move an inch. Not even the test files work. - Insert SD card - Switch on - Beep 3 times - The laser is running when heard. But does not move - Then only the light on the button flashes Does anyone have any tips for me? Or the same problems?

Avatar
avatar
mekinalli

6 months ago

Just a test file in the root folder, then insert the card, start the laser, wait until it starts. that's how it worked for me. did you pull the belts too tight?

avatar
DAWE89

6 months ago

Thank you for the tip.

I had probably tightened them too much. Now it works.