Hello all,

the Roborock2 demonstrably does not vacuum in some areas of some rooms (bathroom + study + living room), it is like a ghost wall, it just stops as if there is a wall in the middle of the room. It is clearly visible on the map via the MI App, it recognises the whole room but this area is not being cleaned.

Does anyone know this problem? Is it possible to force some areas? Of course, there is no area defined in this area that it should leave out... Firmware is updated.

Thank you very much for your support.

Question

Hello all,

the Roborock2 demonstrably does not vacuum in some areas of some rooms (bathroom + study + living room), it is like a ghost wall, it just stops as if there is a wall in the middle of the room. It is clearly visible on the map via the MI App, it recognises the whole room but this area is not being cleaned.

Does anyone know this problem? Is it possible to force some areas? Of course, there is no area defined in this area that it should leave out... Firmware is updated.

Thank you very much for your support.

Answer

Hello
The robot does something similar for me. It also vacuums up to a virtual wall, but at a later time it goes into the 'closed off' area and cleans it too. It seems as if it divides the area into blocks and cleans them one after the other. For me, however, it cleans everything at the end.
Greetings

Search

Question about Roborock S5