Creality Falcon
Question about Creality Falcon
Greetings I have the 10W Falcon; it does what it is supposed to do; results are quite good. What I can't manage is: when I work via the memory card, I can't display the frame; when I start it up and then press the start button, it immediately begins to laser without first displaying the working frame; how can I trigger this? I don't want to leave the laptop connected all the time. thanks for your help and regards
me too; it must have something to do with the storage on the TF card; because, as already mentioned, the FRAME is activated when I want it to be when employees are working from the PC
Hhm, this is incomprehensible to me - when switching on, the laser beeps 3 times and moves to the lower left corner (start position), pressing the button again triggers the frame function, whereby the laser scans the position of the object stored on the map with a faint light and pressing the button again triggers the laser.
Thank you very much for the AW; that can't be it; when I start the sample image, the device goes into frame mode after pressing and then into laser mode after pressing again.
Somehow the "first frame mode commands" do not appear on the TF card with my pictures.
When working directly from the PC, it works.
Somehow the "first frame mode commands" do not appear on the TF card with my pictures.
When working directly from the PC, it works.
Hello,
According to the manufacturer's manual, press the button once:
When the machine is switched on, it emits a "beep, beep, beep". Once the machine has been initialised, it goes into standby mode and the indicator light changes to "breathing".
Press the micro-switch, it enters preview from standby mode, the laser head will emit a dim light and repeat the movement around the largest X, Y edge of the processed image with the light on. At this point, adjust the material to an appropriate position. In preview mode, press the microswitch again, it will switch to engraving mode. At this point, the laser head will emit a strong light, and the machine will begin engraving with the indicator light on.
According to the manufacturer's manual, press the button once:
When the machine is switched on, it emits a "beep, beep, beep". Once the machine has been initialised, it goes into standby mode and the indicator light changes to "breathing".
Press the micro-switch, it enters preview from standby mode, the laser head will emit a dim light and repeat the movement around the largest X, Y edge of the processed image with the light on. At this point, adjust the material to an appropriate position. In preview mode, press the microswitch again, it will switch to engraving mode. At this point, the laser head will emit a strong light, and the machine will begin engraving with the indicator light on.