You're not connected to the Internet.
Supermicro 1028R-TDW (LGA 2011, DDR4-RAM, S-ATA III) Actual product image
CHF 1339.–

Supermicro 1028R-TDW (LGA 2011, DDR4-RAM, S-ATA III)

Specifications

Key specifications

S-ATA III8 x

General information

Manufacturer Supermicro
Product type Server barebones
Item number5296741
Manufacturer no.SYS-1028R-TDW
External links Manufacturer's site (en)

Hardware form factor

Number of rack units
1 U
Design
rack

Motherboard properties

Manufacturer
supermicro
Chipset
Intel C612
Number of CPU sockets
2 x
CPU socket
i

CPU socket

A CPU socket or CPU slot is a mechanical component that provides mechanical and electrical connections between a microprocessor and a printed circuit board (PCB). This allows the CPU to be replaced without soldering.
Common sockets have retention clips that apply a constant force, which must be overcome when a device is inserted. For chips with a large number of pins, either zero-insertion force (ZIF) sockets or land grid array (LGA) sockets are used instead. These designs apply a compression force once either a handle (for ZIF type) or a surface plate (LGA type) is put into place. This provides superior mechanical retention while avoiding the risk of bending pins when inserting the chip into the socket.

More information...

LGA 2011
i

LGA 2011

LGA 2011, also called Socket R, is a CPU socket by Intel. It replaces Intel's LGA 1366 (Socket B) and LGA 1567 in the performance and high-end desktop and server platforms. The socket has 2,011 protruding pins which touch contact points on the underside of the processor.

More information...

Processor family
Intel Xeon E5-2600 v3
,
Intel Xeon E5-2600 v4

Memory

Memory type
DDR4-RAM
Memory form factor
DIMM 288
Memory Slots max
16
Max. RAM
2000 GB
RAM speed
2400 MHz
RAM error correction
ECC
RAM buffer
i

RAM buffer

In addition to bandwidth and capacity variants, modules can
1. Optionally implement ECC, which is an extra data byte lane used for correcting minor errors and detecting major errors for better reliability. Modules with ECC are identified by an additional ECC in their designation.
2. Be "registered", which improves signal integrity (and hence potentially clock speed and physical slot capacity) by electrically buffering the signals at a cost of an extra clock of increased latency. Those modules are identified by an additional R in their designation, whereas non-registered (a.k.a. "unbuffered") RAM may be identified by an additional U in the designation.
3. Be Fully buffered modules, which are designated by F or FB and do not have the same notch position as other classes. Fully buffered modules cannot be used with motherboards that are made for registered modules, and the different notch position physically prevents their insertion.

Registered

Data storage controller

Possible raid configuration
0
i

0

(block-level striping without parity or mirroring) has no (or zero) redundancy. It provides improved performance and additional storage but no fault tolerance.

More information...

,
1
i

1

(mirroring without parity or striping), data are written identically to two drives, thereby producing a "mirrored set"; the read request is serviced by either of the two drives containing the requested data, whichever one involves least seek time plus rotational latency.

More information...

,
5
i

5

(block-level striping with distributed parity) distributes parity along with the data and requires all drives but one to be present to operate; the array is not destroyed by a single drive failure.

More information...

,
10
i

10

A RAID 10 group is a RAID 0 over several RAID 1, combining the characteristics of both RAIDs: security and increased read/write speed.
A RAID 10 network requires at least four hard disks.

More information...

S-ATA III
i

S-ATA III

Serial ATA (SATA) is a computer bus interface for connecting host bus adapters to mass storage devices such as hard disk drives and optical drives. Serial ATA 3 can transfer up to 6 Gbit/s.

More information...

8 x

Hard drives

2.5" (hot plug)
8 x

Expansion slots

PCI Express 3.0 x16
2 x
PCI Express x8
i

PCI Express x8

PCI Express, officially abbreviated as PCI-E or PCIe, is a computer expansion card interface format introduced by Intel in 2004. PCI Express was designed to replace the general-purpose PCI expansion bus, the high-end PCI-X bus and the AGP graphics card interface. Unlike previous PC expansion interfaces, rather than being a bus it is structured around point-to-point serial links called lanes.

More information...

1 x

External interfaces

USB 3.0 type A
3 x
USB 2.0 type A
i

USB 2.0 type A

Universal Serial Bus (USB) is a serial bus standard to interface devices. USB was designed to allow many peripherals to be connected using a single standardized interface socket and to improve the plug-and-play capabilities by allowing devices to be connected and disconnected without rebooting the computer (hot swapping). Other convenient features include providing power to low-consumption devices without the need for an external power supply and allowing many devices to be used without requiring manufacturer specific, individual device drivers to be installed.
The Mini-B, Micro-A, Micro-B , and Micro-AB connectors are used for smaller devices such as PDAs, mobile phones or digital cameras. The Standard-A plug is approximately 4 by 12 mm, the Standard-B approximately 7 by 8 mm, and the Micro-A and Micro-B plugs approximately 2 by 7 mm.

More information...

4 x

Network

RJ45/LAN port
i

RJ45/LAN port

Network connection allows connection to an internal or external network.

More information...

2 x
Max. port speed
i

Max. port speed

Describes the maximum data transfer rate. Is not necessarily supported by all ports.

More information...

1000 Mbit/s
i

1000 Mbit/s

In computer networking, Gigabit Ethernet (GbE or 1 GigE) is a term describing various technologies for transmitting Ethernet frames at a rate of a gigabit per second (1,000,000,000 bits per second).

More information...

Video connections

VGA
i

VGA

A VGA connector as it is commonly known (other names include RGB connector, D-sub 15, mini sub D15 and mini D15) is a three-row 15 pin DE-15. There are four versions: original and DDC2 pinouts, the far older and less flexible DE-9 connector, and a Mini-VGA used for laptops.
The common 15-pin VGA connector found on most video cards, computer monitors, and other devices, is almost universally called "HD-15". HD stands for "high-density", which distinguishes it from connectors having the same form factor but only 2 rows of pins. However, this connector is often incorrectly referred to as a DB-15 or HDB-15.[citation needed]
"VGA connectors" and their associated cabling are almost always used solely to carry analog component RGBHV (red - green - blue - horizontal sync - vertical sync) video signals along with DDC2 digital clock and data.
Where size is a constraint (such as laptops) a mini-VGA port can sometimes be found in place of the full-sized VGA connector.

1 x

Optical drive properties

Optical drive type
No drive

Operating system

Operating system
No operating system

Mains supply properties

Number of power supply units
1 x
Power
600 W
Max. Number of power supply units
1

Product dimensions

Length
597 mm
Width
437 mm
Height
43 mm
Weight
21 kg

Please click directly on the incorrect data to access the registration form.

Alternatively, you can register a generic error report (wrong picture, unsuitable accessories, etc.)

Cancel

This information may include unverified machine translations. Thank you for reporting any incorrect data to translations@digitecgalaxus.ch.

Correction suggestion

Comment

This information may include unverified machine translations. Thank you for reporting any incorrect data to translations@digitecgalaxus.ch.

Returns and warranty

Warranty 36 month Bring-in
30-day right of return
i

30-day right of return

Unfortunately, we cannot accept a product if it is damaged, incomplete or missing its original packaging.

Returns and warranty

Please use our simplified returns and warranty process to return a product or register a warranty case. Returns and warranty

Please use our simplified warranty process to view the warranty period as well as any warranty extensions you may have purchased. This will ensure that your return or warranty case is processed quickly and effectively.

Availability

Mail delivery/Collection

Product is not ready for sale or temporarily not available. No delivery date known.
Not in stock

Request delivery date

The delivery date is unknown or there is currently no information available. Please enter your e-mail address above if you wish to be notified when the product will be available again. An enquiry with our suppliers usually takes 1–3 days. You will automatically receive a notification regarding the next possible delivery day.

Information subject to change.

Matching accessories

Memory

Value RAM (1x, 8GB, DDR4-2133, DIMM 288)
CHF 118.–
Kingston Value RAM (1x, 8GB, DDR4-2133, DIMM 288)
2

Availability

  • approx. 7 – 9 days

If ordered immediately.
Information subject to change.

View details

+1

Processors

Xeon E5-2620 v3 (LGA 2011-v3, 2.40GHz)
CHF 489.–
Intel Xeon E5-2620 v3 (LGA 2011-v3, 2.40GHz)
1

Availability

Mail delivery

  • approx. 2–3 weeks

Collection

  • All locations: approx. 10 – 12 days

If ordered immediately.
Information subject to change.

View details

+2

Server accessories

+1

Questions about this product

No questions so far.

Have a question? Ask the digitec Community.


What's your question to the Community?

The Community terms and conditions apply.
If you have any questions about your order, please contact the Customer service.

Product ratings

Your rating

To what extent does the product meet your expectations?

Supermicro 1028R-TDW (LGA 2011, DDR4-RAM, S-ATA III) Supermicro 1028R-TDW (LGA 2011, DDR4-RAM, S-ATA III)