This is the XBee XBP24-BZ7WIT-004 module from Digi. The new Series 2B
improves upon the power output and data protocol of the Pro Series2.
Series 2B modules allow you to create complex mesh networks based on
the XBee ZB ZigBee mesh firmware. These modules allow a very reliable
and simple communication between microcontrollers, computers, systems,
really anything with a serial port! Point to point and multi-point
networks are supported.
Series 2B modules use a different hardware configuration from the
earlier models and while they will communicate with Series 2 XBee
modules, they are not compatible with the outdated Series 2.5 Modules.
Note: If you are looking for a simple point-to-point configuration,
you might want to try the Series 1 instead. The Series 2 requires
considerable setup and configuration.
Note: Series 1 and Series 2B XBee modules have the same pin-out.
However, Series 1 modules cannot communicate with Series 2B modules.
* 3.3V @ 295mA
* 250kbps Max data rate
* 63mW output (+17dBm)
* 1 mile (1600m) range
* Wire Antenna
* Fully FCC certified
* 6 10-bit ADC input pins
* 8 digital IO pins
* 128-bit encryption
* Local or over-air configuration
* AT or API command set
* Digi XBee Series 2B Page 
* Digi Examples and Guides 
* X-CTU Software 
 http://www.digi.com/support/productdetail?pid=3352 … more
|Product type||Electronics module|
If you wish to learn more about this product, please visit the manufacturer's website or contact us: email@example.com
Warranty 24 month Bring-in
Limited right of return
Please use our simplified returns and warranty process to return a product or register a warranty case. Returns and warranty
Please use our simplified warranty process to view the warranty period as well as any warranty extensions you may have purchased. This will ensure that your return or warranty case is processed quickly and effectively.
Information subject to change.
Have you tested this product? Share your opinion with the digitec community.Rate product
You're not connected to the Internet. Please check that your connection is enabled to keep browsing the site.